Process of making my bullet wound

First stage of making my bullet wound:

1.       Firstly cut off a small amount of modelling clay, you may think you’ll need a lot but you only need a small amount. You can do this using any of the tools but preferably one with a sharp edge.

2.       Then start to mould your clay onto the plastic try, you can use a hair dryer (on the cool setting) to heat it up so it is easier to mould.

3.       Making sure all the edges are as smooth as possible, begin to create to bullet wound by firstly measuring a small circle, I did mine 8mm as this was the size of the bullet used.

4.       Use as many tools as you can to try and create the perfect bullet mould, scrape away edges and make sure that it is smooth.

5.       You can use the hair dryer as much as you want to heat up the clay, it will make it easier to mould.

6.       When you are happy with your mould make sure that you keep it in a safe place if you aren’t going to create the wound straight away, preferably in a plastic container.